Solutions

Moisture problems, mold on ceilings, walls and structural elements (columns, beams) around coastal areas

Solutions

Moisture problems, mold on ceilings, walls and structural elements (columns, beams) around coastal areas

Technical Support +30 2103633512 Mon - Fri: 9:00 - 17:00

POTENTIAL CAUSES OF THE PROBLEM

  • Poor room ventilation
  • Collection of high moisture content in the field
  • Moisture problems from the exterior walls

Product Categories

SOLUTION

STEP 1 Rub the surface and remove loose parts.
STEP 2 Good cleaning of the surface.
STEP 3 Prime the surface of the application with quartz sand primer GLX 298 PREMIUM.
STEP 4 Application of thermal insulation plates on the surface, gluing them with CLIMABOND THC 403 adhesive. In this case, it is strongly suggested that the application of EPS 200 or XPS thermal insulation plates and the application of silicone organic plaster CLIMASIL PLASTER DEC 438.
STEP 5 Application of pegs for holding thermal insulation plates.
STEP 6 Apply the first layer of fiber-reinforced base coat, FIBERPLUS THC 405.
STEP 7 As long as FIBERPLUS THC 405 is still wet, firmly put CLIMAPLUS fiberglass mesh (160 g/m²).
STEP 8 Then, apply a second layer of fiber-reinforced base coat, FIBERPLUS THC 405, to completely cover the mesh.
STEP 9 Prime the surface of application with the colored acrylic primer GLX 494 CLIMA PRIMER.
STEP 10 Apply the organic acrylic-based top coating CLIMA PLASTER DEC 428, tinted to the required shade chosen from the CLIMAPLUS fan deck.
STEP 11 ATTENTION: If the application is in a seaside area or an area with high moisture content, THRAKON recommends our silicone system. In such a case, proceed to the following steps: a) Prime the surface with the colored silicone-based primer GLX 498 CLIMASIL PRIMER. b) Application of organic silicone-based top coating CLIMASIL PLASTER DEC 438, tinted to the required shade chosen from CLIMAPLUS fan deck.

Products Used