Solutions
Damaged plaster repairing (ceiling)
Solutions
Damaged plaster repairing (ceiling)
POTENTIAL CAUSES OF THE PROBLEM
- Insufficient waterproofing on the substrate
- Significant contractions in the substrate
- Application of base coat plaster in a thick layer
- Normal cracking following an earthquake
- Possible application of coatings under improper weather conditions
Product Categories
SOLUTION
STEP 1
Remove all loose plaster particles before proceeding with the repairs.
STEP 2
Use a steel brush to clean all rust and dust from the concrete reinforcement.
STEP 3
Apply REPIFIX WRM 510 with a brush to protect the steel against corrosion.
STEP 4
After 10 minutes, once REPIFIX WRM 510 has dried, lightly spray water on the surface to enhance bonding.
STEP 5
Apply REPIFIX WRM 525 with a trowel, pressing it down to achieve a maximum thickness of 4 cm.
STEP 6
In some cases, you may need to remove plaster from the entire roof surface.
STEP 7
Clean the surface thoroughly, removing any dust and loose particles.
STEP 8
Prime the surface with GLX 298 using a roller or brush.
STEP 9
Apply spray plaster SHP 205.
STEP 10
Apply one coat of NHP 250 white plaster with marble dust.
STEP 11
Rub the surface with a sponged trowel.
STEP 12
If a finer surface is required, use DEC 470 FINE putty. DEC 470 is an extra fine putty that is ideal for both indoor and outdoor applications, leaving a smooth surface without lines, bubbles, or imperfections after drying.
Products Used